Backed with dextrous team of professionals, we are able to provide supreme quality Zinc Phosphate Primer Paint to our clients. The offered paint is precisely processed using premium quality chemicals and sophisticated technology in adherence to international quality standards. It is a phosphate based protective primer that is recommended for protection of equipment, steel structures and conveyors from moderate corrosive conditions under chemical and marine environments. Furthermore, clients can avail this Zinc Phosphate Primer Paint from us at cost-effective price.
Features:
Long shelf life
Accurate composition
Easy to apply
Glossy finish
RECOMMENDED USAGE
Volume Solids | 50+3 % |
Mixing Ratio Base: Hardner | 4 : 1 by volume |
Recommended D.F.T. | 30 - 50 microns |
Theoretical Coverage at given D.F.T. | 10.0-17.0 m2/ltr |
Technical Specifications
Type | Two Pack |
Colour | Grey |
Gloss | Matt |
Induction Time | 30-45 mins |
Pot Life | 6 -8 hrs. at 30oC |
Curing Mechanism | Solvent release and chemical reaction between Base and Hardner |
Flash Point | Not below 25oC |
Drying Time(30oC) | |
Surface Dry | Max. 1 hr |
Hard Dry | 16 - 18 hours. |
Curing Time | 7 days |
Rec-oating Interval | Min 16 hrs. Max 5 days |
Thinner | Emperol Epoxy Thinner |
Suitable Over-coating | Chlorinated Rubber,Epoxy or Polyurethane coating. |
Applied over | Blast cleaned M.S.surface. |
Application Method | Brush / Conventional spray |
Shelf Life | 12 months under normal storage conditions in original sealed container. |
SURFACE PREPARATION
Before application of the primer, all surface must be clean, dry and free from mill scale. Blast cleaning to 2.5 grade of international standard to ISO 8501/1: 1988 is the only satisfactory method of preparing steel surfaces. Manual or mechanical chipping, scraping, and wire brushing to St - 3 grade of international standard is recommended only where blast cleaning is not feasible.
SPECIAL INSTRUCTION
Thinner consumption may vary depending upon site conditions. Practical covering capacity depends on application techniques, ambient conditions, wastage, surface condition etc. Surface temperature must be 3oC above Dew Point to prevent condensation.
Temperature
Air: 5 - 40oC
Surface: 5 - 50oC
EMPEROL COLOURS PVT. LTD.
All Rights Reserved.(Terms of Use) Developed and Managed by Infocom Network Private Limited. |