Established in 1989, our firm is instrumental in manufacturing and supplying high quality Surface Coating Paint. Having good resistance to sea water, mineral oils, petrol, jet fuel, lubrication oil, acids and chemicals, it is highly used in coating the machinery items of fertilizer, chemical and petrochemical industries. Offered paint is precisely formulated using superior quality chemicals and technology at our production unit. Furthermore, our clients can avail this Surface Coating Paint from us in different packaging options at affordable prices.
Features:
Longer shelf life
Accurate composition
Safe to use
Highly effective
RECOMMENDED USAGE
Volume Solids |
80+3 % |
Mixing Ratio |
2 : 1 by volume or 1.240 : 0.485 kg.by weight |
Recommended D.F.T. |
150 - 200 microns |
Theoretical Coverage at given D.F.T. |
4.0-5.0 m2/ltr |
Technical Specifications
Type |
Two Pack |
Colour |
Alu. Grey / Red oxide. |
Gloss |
Semiglossy |
Pot Life |
2 hrs at 30oC |
Curing Mechanism |
Solvent release and chemical reaction between Base and Hardner |
Flash Point |
Not below 25oC |
Drying Time(30oC) |
|
Surface Dry |
Max.4 - 5 hrs. |
Hard Dry |
16-18 hours. |
Curing Time |
7 days |
Recoating Interval |
Min 16 hrs. Max 5 days |
Thinner |
Emperol Epoxy Thinner |
Suitable Overcoating |
Chlorinated Rubber,Epoxy or Polyurethane coating. |
Applied over |
Blast cleaned M.S.surface. |
Application Method |
Brush / Conventional spray / Airless Spray. |
Shelf Life |
12 months under normal storage conditions in original sealed container. |
SURFACE PREPARATION
Before application of the primer, all surface must be clean, dry and free from mill scale. Blast cleaning to Sa 2.5 grade of international standard to ISO 8501/1: 1988 is the only satisfactory method of preparing steel surfaces. Manual or mechanical chipping, scraping, and wire brushing to St - 3 grade of international standard is recommended only where blast cleaning is not feasible.
SPECIAL INSTRUCTION
Thinner consumption may vary depending upon site conditions. Practical covering capacity depends on application techniques, ambient conditions, wastage, surface condition etc. Surface temperature must be 3oC above Dew Point to prevent condensation.
Temperature
Air: 5 - 40oC
Surface: 5 - 50oC
EMPEROL COLOURS PVT. LTD.
All Rights Reserved.(Terms of Use) Developed and Managed by Infocom Network Private Limited. |