We are actively engaged in manufacturing and supplying high quality Coal Tar Epoxy Paint. This paint has excellent resistant to mild chemicals, corrosive and marine atmosphere, therefore, highly used in chemical plants, material handling facilities in ports, pipeline and storage tanks, void spaces, chain lockers, waste water and sewage treatment plants etc. The offered epoxy paint is formulated under the guidance of skilled professionals utilizing high grade chemicals at par with international quality standards. This epoxy finish paint is tested on various parameters to ensure it's quality as per the set industry standards. Furthermore, clients can avail this paint from us at reasonable prices.
Features:
High adhesion power
Chemical and oil resistant
Accurate composition
Easy to apply
RECOMMENDED USAGE
Volume Solids | 65+3 % |
Mixing Ratio | 3 : 1 by volume or 100 : 125 microns |
Recommended D.F.T. | 100 - 125 microns |
Theoretical Coverage at given D.F.T. | 5.0-6.5 m2/ltr |
Technical Specifications
Type | Two Pack |
Color | Black |
Gloss | Matt to eggshell |
Induction Time | 30 - 45 mins |
Pot Life | 6 - 8 hrs. at 30oC |
Curing Mechanism | Solvent release and chemical reaction between Base and Hardener |
Flash Point | Not below 25oC |
Drying Time(30oC) | |
Surface Dry | 4 hrs |
Hard Dry | 48 hrs |
Full Cure | 7 days |
Recoating Interval | Min 16 hrs. Max 72 hrs |
Thinner | Emperol Epoxy Thinner |
Applied over | Blast cleaned / primed steel, Concrete. |
Application Method | Brush / Conventional spray / Airless Spray. |
Shelf Life | 12 months under normal storage conditions in original sealed container. |
Applied over | Blast cleaned / primed steel, Concrete. |
Application Method | Brush / Conventional / Airless Spray |
Shelf life | 12 months under normal storage conditions in original sealed container. |
SURFACE PREPARATION
Before application, all surface must be clean, dry and free from mill scale. Blast cleaning to Sa 2.5 grade of international standard to ISO 8501/1: 1988 is the only satisfactory method of preparing steel surfaces. Manual or mechanical chipping, scraping, and wire brushing to St 3 grade of international standard is recommended only where blast cleaning is not feasible.
SPECIAL INSTRUCTION
Thinner consumption may vary depending upon site conditions. Practical covering capacity depends on application techniques, ambient conditions, wastage, surface condition etc. Surface temperature must be 3oC above Dew Point to prevent condensation.
Temperature
Air: 5 - 40oC
Surface: 5 - 50oC
EMPEROL COLOURS PVT. LTD.
All Rights Reserved.(Terms of Use) Developed and Managed by Infocom Network Private Limited. |